The Atlas Stone Finishing Kit works well for grinding atlas stones, patching and sanding imperfections, helping to finish atlas stones to the highest quality.

Kit includes:
(1) 4 lbs of DryLok Atlas Stone Patch
(10) Sheets of 120G Drywall Sanding Screen
(1) DeWalt Grinding Wheel (fits a 5/8" shaft on an angle grinder)

* It is a must to use safety glasses, dust mask, protective gloves and appropriate protective gear to help protect yourself from dust and debris.

* This kit does not include an angle grinder which is needed to us the diamond grinding wheel

Stone Mold Release is an absolute must-have for Atlas Stone making. Without lubricating the inside of the mold before pouring concrete, the two halves are very difficult to separate. Use Blaster Stone Mold Release to lubricate the two halves and prolong the life of the mold. 

Size: 11oz.

Add custom stone mold lettering to your Slater Atlas Stone Mold! Lettering is limited to 25 characters. We guarantee that the lettering will hold for at least one atlas stone. If placing an order for multiple stone molds, you should purchase the same amount of labels as molds, or specify which mold you would like the label installed. 

When placing an order, please include what you would like your lettering to read in the order notes located on checkout page. For questions, please email landon@slatershardware.com 

A little goes a long way! Use High-Performance Mold Release to make taking the mold off of the stone a breeze!

Lightly spray the lubricant on the inside of the mold, spread it will a paper towel, and carry on with the rest of the mold assembly process.

The absolute best tape to use on your Slater Atlas Stone Mold. We so strongly recommend using this tape that we do not sell any other tape on our website, nor use any other tape in our stone-making. By our best estimate, using Gorilla Tape on your mold only costs $1.15 per stone. 

Specs:

• 1.88" wide x 30 yards long
• 17 mil thick 
• Tight weave, reinforced backing
• Weather-resistant shell 

Lighten your atlas stone by adding a High Density Foam Lightening Insert to the mix. We use high quality foam so the heat caused from the curing of the concrete does not degrade the foam in concrete. We recommend planning to leave at least 4" of concrete on either side of the insert to reduce the risk of the stone breaking. We also recommend including Concrete Strengthening Fibers and a high strength concrete mix (Quikrete 5000, etc.) if adding a lightening insert to the stone. Instructions for installing Lightening Inserts are mentioned in the instruction sheet included with each order, or can be found here. 

Use to shrink wrap your molds after taping them and prior to filling them with concrete.The shrink wrap is great for extra support and works especially well to help keep your molds clean. Just cut the wrap off after your concrete is set up and your mold is still clean!

Include our large-poly, super-strong polypropylene/polyethylene blended synthetic macro-fibers in your concrete mix to assure the strongest possible stone. These fibers act like mini re-bar, successfully replacing steel fibers, welded wire mesh, and conventional reinforcing bars in the stone. Fibers increase overall durability, fatigue resistance, and flexural toughness of the stone. Bulk mixture includes (1) 12oz bulk bag or box of fibers, equivalent to around 8 small bags of fibers. 

Small Bag - Include with wet concrete mix:

• 8"-12" Stone: 1/2 Bag
• 14"-18" Stone: 1 Bag
• 20"-24" Stone: 2 Bags

Bulk Box - Include with wet concrete mix:

• 8"-12" Stone: Small Handful
• 14"-18" Stone: Large Handful
• 20"-24" Stone: Two Large Handfuls